Ready-made Emerson tone block, for STRAT S5-500K (500 kOm)

S5-500K Ready-made Emerson tone block, for STRAT (500 kOm)

Only the most excellent components are used here, which work and sound much better than the factory electronics in your guitar. The potentiometers are accurate and work consistently, without any rustling. Emerson's paper-oil condensers sound amazing! The same capacitors were used in vintage Fender and Gibson. Finished timbre blocks are soldered manually in the USA, Broken Arrow, Oklahoma. The quality and accuracy of soldering are admired, and electronic components will work reliably for many years. Evaluate the advantages of Emerson timbre blocks not only visually, but also directly in the sound of your instrument.

The set consists of:
- Potentiometers CTS 500 kOhm (stem length 3/8") - 3 pcs.
- Oak Grigsby 5-way switch - 1 pc.
- Switchcraft 1/4" Mono sockets - 1 pc.
- Emerson 0.022 uf oil-paper condenser - 1 pc.
* (0.047 uf are used with 250kohm potentiometers)
- Volume modifier (470 pf capacitor soldered in parallel with a 220 kOhm carbon film resistor to maintain clarity of sound with the volume knob slightly turned) - 1 pc.
- Desoldering schemes

Control: volume, two tones.

Switch diagram:

1. Bridge
2. Bridge Neck (parallel)
3. The Center
4. The center of the Neck (parallel)
5. Some

Since the timbre block has American potentiometers with 24 teeth, Asian guitars will need to replace the knobs to the inch standard. It is recommended to carefully place the handle on the potentiometer so that the teeth and grooves match, and then smoothly sink the handle to the end without unnecessary effort.

The control panel, the nozzle on the switch and the knobs of the potentiometers are not included in the package.